Mercedes-Benz 380 SL 1984, Руководство пользователя

Страница: 36 / 89

Radio
To adjust the tone characteristic
To set the radio to a “flat”
frequency response, briefly press
both tone controls O B
simultaneously.
To produce more bass, press the
bass control only n . To produce
more treble, press the treble
control only Q
.
Note:
Repeated pressing of either the
bass or treble control will cause the
respective tone control to alternate
between an increasing and
decreasing setting.
To select AM or FM
Press any of the buttons marked
0 3 through S 3 to tune the radio to
the FM band.
Press any of the buttons marked
EQ through EQ to tune the radio to
the AM band.
To tune to a station
Stations can be tuned in by using
automatic search, direct frequency
dialing, manual tuning, or by preset
push buttons. The frequency of the
station selected is displayed
digitally on the display panel.
Automatic station search
Switch to the wave band desired
by pressing any of the following
buttons:
for FM, buttons EO through S 3 ,
for AM, buttons £ □ through QQ .
By pressing the automatic station
seeker bar Q Q X f f l upward the
radio will search for stations in
ascending frequencies, by pressing
down in descending frequencies.
The direction of automatic search­
ing can be reversed by pressing
the bar in the respective
direction. In order to arrive at a
desired station faster, the bar has
to be held down in the desired
direction.
The radio is programmed to
automatically search the entire
band in three sensitivity modes.
During its first sweep, only the
most powerful stations received will
be selected and locked in. During
the next sweep, the less powerful
and during the third cycle, also the
weak stations will be locked in.
If the station seeker bar is activated
within 8 seconds after the radio is
tuned to a station, then the search
operation will be continued at the
same sensitivity level. If 8 seconds
are exceeded, the radio will revert
to searching only the most powerful
stations.