Mercedes-Benz 2010 C 250, Руководство оператора

Страница: 318 / 364

Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X
Switch off the ignition.
X
Turn the exterior lamp switch to position
$
.
X
Open the trunk.
Tail lamp unit
X
Driver’s side: Lift up the bottom and pull out
the trim panel covering the driver side rear
light.
X
Passenger side: Open the fuse box in the
trunk (
Y
page 329).
X
Disconnect electrical connector
;
.
X
Pull tabs
:
in direction of arrows.
X
Remove the bulb carrier.
Bulb carrier
=
Side marker lamp
?
Rear fog lamp (driver’s side only), side
marker lamp
A
Backup lamp
B
Tail lamp, brake lamp
C
Tail lamp, brake lamp, parking and
standing lamp
D
Turn signal lamp
Side marker lamp
X
Turn the bulb socket on backside of tail
lamp unit counterclockwise and remove
side marker lamp
=
with bulb socket.
X
Turn the new bulb with socket on backside
of tail lamp unit clockwise until it engages.
Other lamps
X
Depending on which bulb needs to be
replaced, press gently onto the respective
bulb and turn it counterclockwise out of its
bulb socket.
X
Gently press the new bulb into its bulb
socket and turn it clockwise until it
engages.
Reinstall bulb carrier
X
Reinstall the bulb carrier and let tabs
:
(
Y
page 316) engage.
X
Connect the electrical connector
;
(
Y
page 316) until it engages.
X
Reinstall trim panel.
Replacing wiper blades
Safety notes
G
Warning!
For safety reasons, switch off the wipers and
remove the SmartKey from the starter switch
(vehicles with KEYLESS-GO: Make sure the
vehicle’s on-board electronics have status
0)
before replacing a wiper blade. Otherwise, the
wiper motor could suddenly turn on and cause
injury.
316
Replacing wiper blades
Practical hints
204_AKB; 5; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T17:54:06+02:00 - Seite 316