Mercedes-Benz 2008 C 300 4MATIC Sport, Руководство оператора

Страница: 135 / 406

X
Pull out the plug.
X
Turn fender nut : 90° counter-clockwise
and remove the bulb holder.
X
Turn signal lamp ; ; : lightly press the bulb
into the bulb holder, turn it counter-clock-
wise and remove it from the bulb holder.
X
Insert the new bulb into the bulb holder and
turn it clockwise.
X
Backup lamp = = : remove the bulb from
the bulb holder.
X
Insert the new bulb into the bulb holder.
X
Re-install bulb holder.
X
Turn fender nut : 90° clockwise.
X
Insert the connector.
X
Close the side trim panel (
Y
page 132).
Windshield wipers
Switching the windshield wipers
on/off
!
Do not operate the windshield wipers
when the windshield is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windshield can
scratch the glass if wiping takes place when
the windshield is dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always
use washer fluid when operating the wind-
shield wipers.
!
If the windshield wipers leave smears on
the windshield after the vehicle has been
washed in an automatic car wash, wax or
other residues may be the reason for this.
Clean the windshield using washer fluid
after washing the vehicle in an automatic
car wash.
!
Intermittent wiping with rain sensor: due
to optical influences and the windshield
becoming dirty in dry weather conditions,
the windshield wipers may be activated
inadvertently. This could then damage the
windshield wiper blades or scratch the
windshield.
For this reason, you should always switch
off the windshield wipers in dry weather.
1
$ Windshield wiper off
2
Ä Intermittent wipe, low (rain sensor
set to low sensitivity)
3
Å Intermittent wipe, high (rain sensor
set to high sensitivity)
4
° Continuous wipe, slow
5
¯ Continuous wipe, fast
B
í Single wipe/ î To wipe the wind-
shield using washer fluid
Windshield wipers
133
Lights
and
windshield
wipers
Z