Mercedes-Benz 2001 M-Class, Руководство оператора

Страница: 430 / 466

X
Clean the wheel and wheel hub contact
surfaces.
X
Slide the wheel to be mounted onto the
alignment bolt and push it on.
X
Tighten the wheel bolts until they are fin-
ger-tight.
X
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
tight.
Lowering the vehicle
G WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
X
Place the ratchet wrench onto the hexagon
nut of the jack so that the letters AB are
visible.
X
Turn the ratchet wrench until the vehicle is
once again standing firmly on the ground.
X
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
wise pattern in the sequence indicated ( :
to A ). The tightening torque must be
110 lb-ft (150 Nm).
X
Turn the jack back to its initial position.
X
Stow the jack and the rest of the tire-
change tool kit in the stowage well under
the cargo compartment floor again.
X
Check the tire pressure of the newly moun-
ted wheel and adjust it if necessary.
Observe the recommended tire pressure
(
Y
page 404).
i
Vehicles with tire pressure monitor: all
wheels mounted must be equipped with
functioning sensors.
Wheel and tire combinations
General notes
!
For safety reasons, Mercedes-Benz rec-
ommends that you only use tires and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These tires have been specially adapted for
use with the control systems, such as ABS
or ESP
®
, and are marked as follows:
R
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
(tires featuring run-flat characteristics)
R
MO1 = Mercedes-Benz Original (only cer-
tain AMG tires)
Mercedes-Benz Original Extended tires
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tires, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with a load, tire dimen-
sion variations could cause the tires to
come into contact with the bodywork and
axle components. This could result in dam-
age to the tires or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tires,
wheels or accessories other than those tes-
ted and approved.
428
Wheel and tire combinations
Wh
eels
and
tires