Merax WQP4-6204, Инструкция по эксплуатации

Страница: 17 / 22

E01
Error code
E02
E03
E04
Cause Remedy
E05
1 . ean the appliance about 30°to 45°to pour out the water in L
the bottom plate,
2.Check if the drainage pipe is placed too high,
3.Check if the pipe be tired a knot, blocked or pressed,
4.Check if the appliance be placed right
5.Exclude above cause, try to restart the appliance again.
Please contact the after-sales service department.
E06
Error code list
The washing powder
and washing tablet
have not been
cleaned up
1.The holes of spray arm been blocked,
the washing powder can not be fiushed
out.
Run the quick wash mode again and put
moderate washing powder as instruction next
time.
Clean the holes of spary arms and run the
quick wash mode again to clean the utensil.
2.Put too much washing power .
Use specialized washing powder and washing
tablet with quick wash mode to wash the
utensil again
Some foam in the
liner
If there's not much foam,you can open the door
and let the foam come less and less; If there's
too much foam,you can remove it with tools. At
last,restart any programme about 3 minutes.
Redo this again and again until the foam is
disappear
Didn't use speciallized washing powder
or put too much washing powder in it
3. Used low-quality washing power
It's normal and it won't impact the
utensil
Some drops in the
inner of liner
Problem
Cause Remedy
Utensils is wet
2.The washing process is still running
3.Programme selected without drying
Refer to utensils place rule
Wait until process finished
Select programme with drying (See overview
of programmes.)
1.Utensils be piled up and without lean
E10 Water inflow abnormal
1.The tap was not fully opened.
2
. Small inflow and low water pressure.
3 . Start-up multiple times in case of water shortage .
4 . Please contact the after-sales service department.
4 . Improper placement of detegent
Reference “ Adding detergent ”
F-01
Service Information
Thermistor short circuit
Thermistor open circuit
Please contact the after-sales service department
The machine is not
heated
1. Please make sure the utensils be placed correctly. Water will
be lack if it is in the plate/bow.
2. Please contact the after-sales service department
Inlet valve failure
Overflow
Heating function
abnormal
Please contact the after-sales service department
Please contact the after-sales service department
Please contact the after-sales service department
Common fault approach
The air renewal system is working
It's normal situation
Appliance makes the
noise as blowing
something when is
plugging. And the
dispaly shows‘FAN’