19
GB/MT
Operation / Maintenance / Cleaning and care / Disposal
Fixing the single beds together
If need be, the two single air beds
10
can be fixed
together either on top of each other or side by side
in order to raise the surface you can lie on or to
expand it.
Push the buckles
4
into each other to close
the buckles
4
(see Fig. D 1–2).
Press the buttons of the buckles
4
down and
pull them apart in order to open the buckles
4
(see Fig. D 3–4).
Fixing them on top of each other:
Remove the pillow
11
from one of the air beds
10
and place the other air bed
10
flush on top
of it (see Fig. E).
Close the buckles
4
on the side as described
above.
Fixing the beds side by side:
Place the two air beds
10
next to each other
so that the ends with the pillows
11
point in the
same direction (see Fig. C).
Close the buckles
4
as described above.
Maintenance
Mending airbed and pillow
Note:
Minor damage may be repaired using the
supplied self adhesive repair patches
9
.
First let the air out of the product (see “Deflating
airbed and pillow”).
Clean the damaged area with alcohol.
Abrade the area around the site of the damage
with fine sandpaper.
Cut out a piece of the repair patch
9
.
Note:
Make sure that the repair patch largely
overlaps the edges of the leak.
Round the corners off and place the repair
patch over the leak or hole. Use a pencil to
draw around the edges of the repair patch.
Place the repair patch onto the damaged part.
Press the repair patch firmly down onto the
leak. You may have to place a heavy object
onto the relevant area.
Wait for 24 hours before you pump up the
product again.
Cleaning and care
Do not use corrosive or abrasive cleaning
agents.
Clean the flocked surface of the product using
a brush.
Clean the plastic surfaces with water and / or
a little mild soap solution.
Do not expose the product to extreme weather
conditions such as extreme temperature, wind
and rain.
Do not allow the product to be subjected to frost.
Ensure that the inside and outside of the product
are completely dry if you intend to store it
indoors for a long period. Failure to observe
this advice could result in the build-up of mildew
and mould.
Fold up the product with the flocked surface on
the inside.
Store the product in dark, dry place – out of
reach of children.
The ideal storage temperature is between
10 and 20 °C.
Make sure that the valve
2
,
8
is shut if you
wish to store the product for any length of time.
Do not allow sharp objects to come into con-
tact with the product while it is in storage.
Never powder the product with talcum.
Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
102583_mer_Luftbett_Content_ES_IT_PT.indd 19
16.07.14 12:30
