Menumaster DECS11MA, Руководство по обслуживанию

Страница: 13 / 44

4-7
PROGRAMMING
Preprogrammed Number Pads
Oven has 10~20 preprogrammed number pads. Follow
instructions below to program heating times and power
levels for customized cooking.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
“PROGRAM” indicating program mode.
3. Press desired number pad.
• Display shows heating time, “COOK LEVEL” and
power level if other than 100 percent power.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds, press
2, 3, and 0 pads.
5. Press desired power level pad to change power level.
• If a power level pad is not pressed, oven defaults to
100% power.
• For example, pressing MEDIUM 50% pad sets oven to
50% power.
• Display shows current power level if other than 100%
power.
6. Press START pad to save new heating time and power
level in oven memory.
• Repeat step 3-6 to program additional pads.
7. Press RESET pad or close oven door to exit
programming mode.
Multiple Heating Stages
Follow instructions below to program oven to perform 3
consecutive heating cycles without interruption.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds.
3. Press desired number pad.
• Display shows heating time and preprogrammed
number.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
5. Press desired power level pad to change power
level.
• If a power level pad is not pressed, oven defaults to
100% power.
• For example, pressing MEDIUM 50% pad sets
oven to 50% power.
• Display shows current power level if other than 100
percent power.
6. Press TIME ENTRY pad.
• Display briefly shows "STAGE 2" . Then cook time
and power level for stage show in display.
• Repeat steps 5-6 to create additional stages.
7. Press START pad to save new heating time and
power level in oven memory.
8. Press RESET pad or close oven door to exit
programming mode.