mensor PCS 400, Руководство по эксплуатации

Страница: 28 / 118

*
*
*
[+] Control Pressure Stable: Sets parameters for pressure stable signal [S].
[=] Window: Enter pressure value acceptable as stable pressure; default is +/–
0.004% FS.
[+] Delay: Set number of consecutive valid readings required (approx 33/sec) to
indicate pressure stable; max 999 = approx 16 sec; default 67 = approx 2.0
sec.
[+] Pressure/Rate/Peak: Selects the format to appear on the bottom line of the display.
(See additional text under ‘Rate Mode’.)
[=] Display Pressure: Normal, default condition.
[+] Rate/Minute: Display rate of change per minute of the measured pressure.
[+] Rate/Second: Same as above except time is per second.
[+] + Peak: Latches and displays the highest measured pressure since last reset;
press [CE] to reset.
[+] – Peak: Latches and displays the lowest measured pressure since last
reset; press [CE] to reset.
[+] Display Resolution: Select number of display characters for pressure value;
characters include numbers and a decimal point when needed.
[=] 5 Characters;
[+] 6 Characters;
[+] 7 Characters; default value.
[+] Restore Defaults: Returns settable parameters to their default values. (Default
values are defined under the heading ‘Default Values’ later in this section.)
[+] Change Passwords: Two password levels are provided; the master password
allows access to all protected functions, including changing both passwords. The
master (Calibration) password was set at the factory to 123456. Both the master
and the lower level (Zero) password can be set or changed after entering the master
password. (See the text under ‘Dual Passwords’.)
[=] Zero: Set or change the zero password.
[+] Master: Change the master password.
[4] METRIC Converts all pressure readings to the metric units selected by the user from
the menu.
PCS 400
LOCAL OPERATION
www.mensor.com 3-5