7 |
P a g e
85-03-00891
REMOTE TRANSMITTER OPERATING INSTRUCTIONS
TO TURN ON THE APPLIANCE
:
1. Press the ON/OFF button. The transmitter display will show all active icons on the screen.
2. Select the Thermostat Mode by pressing the Thermostat Key: OFF (meaning Manual Mode),
ON (meaning normal Thermostat) or Smart (meaning Smart Mode).
a. In OFF (Manual Mode), the appliance will ignite and start on HI.
b. In ON (Normal Thermostat Mode), the appliance will only ignite if the Set Temperature is
greater than the Room Temperature.
c. In SMART (Smart Mode), the appliance will only ignite if the Set Temperature is greater
than the Room Temperature.
TO TURN OFF THE APPLIANCE
, press the ON/OFF button.
MODE KEY:
Pressing the MODE KEY toggles between the var-
ious available functions: Flame Height, Fan Speed, Accent Light
Dimmer and Secondary Burner On/Off.
Flame Height:
6 flame height Levels are available. While the Flame Height
Icon is displayed, pressing the Up or Down button once will
increase or decrease the flame height by 1 of 6 increments. If
the flame height is at Level 1 and the Down button is pressed,
all burners will turn OFF. If in IPI mode, the pilot light will also
extinguish. If in Standing Pilot Mode, the pilot light will remain
ON. Note: If in SMART model, the flame height function is not
available for manual adjustment. In SMART mode, the flame height regu-
lates automatically.
Fan Speed Control:
The fan speed can be adjusted through six (6)
speeds and OFF. To activate this function, press the MODE Key to
index to the fan control icon. Use the UP/Down Arrow Key to turn
ON, OFF or adjust the fan speed. A single “beep” will confirm recep-
tion of the command. Once you set the desired fan control, the sys-
tem will remember your selected fan speed until you manually change it.
Accent-Light Dimmer:
This function controls the Mendota Accent
Light functions. Pressing the UP key in this mode will TURN ON the
Accent Light and allow you to control the brightness of the Accent
Light in 6 steps. A single “beep” will confirm reception of the com-
mand. Once you set the desired light brightness, the system will re-
member your selected brightness level until you manually change it.
Secondary Burner:
This function controls the Secondary Burner’s
ON/OFF feature. Pressing the UP Key in this mode will TURN ON
the Secondary Burner and Pressing the DOWN Key will TURN OFF
the Secondary Burner. The flame level will not change when you
turn the Secondary Burner On or Off. The flame level can only be
changed in the Flame Level mode.
NOTE: The “AUX” function is not available and shall be skipped over.
