Part No. 2320-0138
2. Mounting Instructions, continued
Fig. 3
3. Loosely install the four Fork Clamps on the forks, ap-
proximately 2" apart. (Fig 2).
4. Start with Fork Clamp Bushing adjusted to rear of slot
(Fig 3) Then adjust as needed and check for clearance.
(See warning above.)
5. Slip the mounting plates and fairing onto the fork clamps,
(see figure 4) and secure the left and right side locking
mechanism
6. Adjust the height, angle and alignment of the windshield
and tighten
ALL
bolts.
Note: This is a detachable windshield, ALWAYS make
sure the Locking Mechanism is Fully Engaged after
installing the windshield! (see figure 5)
Fig. 4
Fig. 2
Trigger Lock Mounting Kit
Bullet Fairing
FXSB Breakout
Fig. 1
Tabs face in
towards headlight
.
WARNING:
"Mounting clamps
backwards will cause
damage to your tank."
Side view. When installed correctly,
Allen bolts are tightened from the
back side of the fork, not the front.
CORRECT
Throttle side,
front of bike
INCORRECT
Throttle side,
front of bike
Loosen Allen Screw to
adjust Bushings to desired
windshield angle.
Rear of slot
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
1
2
3
4
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
R322C/T
LATCH
ASSEMBLY
#memphisshades
