Seite 11 von 20
14.
Close the printhead latch. When the printhead latch is closed, the printer will prime, clean
and cap the printhead automatically. This operation will generally take a minute or two,
and will be obvious from sounds emanating from the printer.
NOTE:
The Printer may take up to 12 minutes to set itself up during initial startup. This is normal.
The machine will emit a number of chirps, whirrs and other noises as it circulates ink and runs
systems.
CAUTION
Do not remove the Printhead while fluid is primed in the system!
Power on the Printer
After the print head and the ink tanks are installed, switch on the printer. For that please
switch on the mains switch and the POWER-button should lights up: this will power up the
print engine and the controllers.
After few seconds, you will hear the ink pump starting to prime the system, then the wiper
will wipe the print head and starts its first maintenance. This can take up to 10-15 minutes
but it is normal so please wait until the toolbox for the system indicates that it is in the
ready state.
Media Handling
Print Area
Print area can be found on the back of the printer where the operator needs to feed the
materials. Any media type must go through the metal paper guide in order to avoid any
movement during printing.
Picture of Paper guide
