Meltem M-WRG-II Series, Инструкция по разборке

Страница: 12 / 14

Dismantling instructions
Ventilation units from the M-WRG-II series
- 12 -
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4 · D-82239 Alling
info@meltem.com · www.meltem.com
VENTILATION THE RIGHT WAY
V E N T I L A T I O N & H E A T R E C O V E R Y
5 Material list
Component Material Item in fig.
Air grille ABS Item 6 in Fig. 3
Electronics compartment covers ABS Item 2 in Fig. 3
Housing ABS Item 4 in Fig. 8
Intermediate plate ABS Item 5 in Fig. 3
Unit cover ABS Item 2 in Fig. 1
Extract air filter ABS/filter medium Item 1 in Fig. 2
Outdoor air filter ABS/filter medium Item 2 in Fig. 2
Heat exchanger Aluminium/plastic Item 2 in Fig. 4
Intermediate plate seal Cellular rubber
EPDM
Item 5 in Fig. 3
Sealing profiles Elastomers Item 3 in Fig. 4
Sealing rings on air spigots Elastomers Item 1 in Fig. 9
Cables Electrical component –
Connection PCB for flap motor Electrical component Item 1 in Fig. 11
Control PCB Electrical component Item 4 in Fig. 7
Distributor PCB Electrical component Item 2 in Fig. 8
Exhaust air fan Electrical component Item 1 in Fig. 5
Flap motor Electrical component Item 3 in Fig. 11
Interface PCB Electrical component Item 2 in Fig. 7
Mains switch Electrical component Item 1 in Fig. 10
Membrane touch pad Electrical component Item 6 in Fig. 7
Ribbon cables Electrical component –
Sensors Electrical component Item 1 in Fig. 6
Supply air fan Electrical component Item 4 in Fig. 5
Housing internal seal EPDM Item 5 in Fig. 7
Holder over distributor PCB PE foam Item 1 in Fig. 8
Insulation on housing back panel PE foam Item 2 in Fig. 9
Seal in the electronics compartment PE foam Item 1 in Fig. 4
Antenna holder with film antenna PE foam/electrical
component
Item 3 in Fig. 7
Filter cover PS Item 2 in Fig. 2
Filter ring PS Item 1 in Fig. 2
Insulation on back of the unit cover PU foam Item 2 in Fig. 1
Filter channel insulation pieces for extract
air/supply air
PU/PE foam Item 4 in Fig. 4
Screws Steel –
Table 1: Material list for the components installed in the M-WRG-II ventilation unit