Meltem M-WRG-II Series, Инструкция по разборке

Страница: 7 / 14

Dismantling instructions
Ventilation units from the M-WRG-II series
- 7 -
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4 · D-82239 Alling
info@meltem.com · www.meltem.com
VENTILATION THE RIGHT WAY
V E N T I L A T I O N & H E A T R E C O V E R Y
4.4 Remove the electronics
compartment covers and
intermediate plate
Fig. 3: Remove the electronics compartment covers and
intermediate plate
1
1
2
2
3
4
5
6 6
► Use the Torx screwdriver TX10 to loosen the
two screws (item 1 in Fig. 3) on the elec-
tronics compartment covers.
► Lift the two electronics compartment covers
(item 2 in Fig. 3) away.
► On the electronics compartment cover with
the On/Off switch, detach the connecting
cable from the PCB in the ventilation unit.
► Remove the seal (item 3 in Fig. 3) with a
slotted screwdriver.
► Use the Torx screwdriver TX20 to loosen the
13 screws (item 4 in Fig. 3) on the interme-
diate plate.
► Lift up the intermediate plate (item 5 in
Fig. 3) with the two air grilles (item 6 in
Fig. 3).
► Remove the intermediate plate seal on the
back of the intermediate plate.
4.5 Remove the heat exchanger
Fig. 4: Remove the heat exchanger
1
2
4
4
3
3
3
3
3
3
► Remove the seal (item 1 in Fig. 4) from the
electronics compartment.
► Lift out the heat exchanger (item 2 in Fig. 4).
► Remove the 6 sealing profiles (item 3 in
Fig. 4).
► Remove the filter channel insulation pieces
(item 4 in Fig. 4) on the extract air and
supply air sides.