Meltem 5010, Руководство по установке

Страница: 26 / 32

Installation manual
M-WRG-S...
- 26 -
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4 · D-82239 Alling
info@meltem.com · www.meltem.com
VENTILATION THE RIGHT WAY
V E N T I L AT I O N & H E AT R E C O V E R Y
11 Installing the ventilation unit
11.1 Removing the cover from the
ventilation unit
► Using both thumbs, press the two latches
(item 1 in Fig. 22) on the bottom of the
ventilation unit. The cover will come
away.
► At the same time, push your index fingers
into the gap between the cover and
housing, and lift the cover away from the
housing.
11.2 Inserting fixing screws with
centring guides into the ventilation
unit
► Take the four 5 x 100 mm (flush-mount)
or 5 x 120 mm (surface-mount) cross-
head screws, four washers and four
centring guides (see Fig. 5 on page 14)
from the ventilation unit set.
► Place the washers (item 1 in Fig. 23) on
the cross-head screws (item 2 in Fig. 23)
and introduce them into the holes in the
housing (item 3 in Fig. 23).
► Screw the four centring guides (item 4 in
Fig. 23) onto the four cross-head screws
at the back until the tip of each cross-
head screw protrudes roughly 10 mm
over the centring guide.
11.3 Removing the supply air hood
► Use the screwdriver to loosen the screw
(item 1 in Fig. 24) on the supply air hood
(item 2 in Fig. 24).
► Hold the supply air hood by the curved
walls and press against the pressure
point (item 3 in Fig. 24). This will release
the latch connection and you can now
remove the supply air hood.
Fig. 22: Removing the cover from the ventilation unit
1
1
Fig. 23: Inserting the fixing screws
1
2
3
4
Fig. 24: Removing the supply air hood
3
2
1