Power
Fault display
Multifunction
The unit display
Instructions of Buttons
Switch:
long press the power button to turn on/off the power;
Acceleration:
press the right acceleration button to start and accelerate;
Brake:
hold the brake handle to brake.Lightly step on the rear fender to assist the brakes
Short press the function key to directly adjust the speed
Beginner mode: no characters in the gear position
Normal mode: gear characters display white
Sports mode: gear characters display red
Headlights:
Press the function button twice shortly to turn on the headlights, and the taillights are always on;
In the light-on state, press the function button twice shortly to turn off the headlights and taillights;
Cruise mode:
keep the current speed for 6 seconds to enter the cruise mode;
Exit the cruise mode when pressing accelerator again or brake.
2.2 Pre-assembly instructions
1.Pull up the lever while pressing
down the rear wheel fende.r
2.Raise the pole,Fasten the folding
spanner,And use the folder fixing
ring to fix the folder wrench.
3.Fix the brake lever with M6 hex
wrench.
4.Tighten handlebars(Pay attention
to the direction of rotation when
tighten).
5.According to the shaking condition
of the pole, properly adjust the folder
screw
LCD Display
Throttle button
Power switch
Function button
Brake handbar
Speed
Gear
LCD display
1
2
3
4
5
6
08
07
