ConnectX®-3 Pro 10Gb/s Ethernet Single and Dual SFP+ Port Network Interface Card User Manual for OCP
Rev 1.1
Mellanox Technologies
15
3
Hardware Installation
3.1
System Requirements
3.1.1
Hardware
This card requires a PCI Express connector as specified in the Open Compute Project Intel Moth-
erboard spec v2.0.
3.1.2
Operating Systems/Distributions
Please refer to
Section 1.3, “Operating Systems/Distributions,” on page 12
3.1.3
Software Stacks
Mellanox OpenFabric software package - MLNX_EN for Linux, WinOF for Windows and ESX
5.1 for VMware. See
Chapter 4, “Driver Installation”.
3.2
Safety Precautions
1. Remove any metallic objects from your hands and wrists.
2. Make sure to use only insulated tools.
3. Verify that the system is powered off and is unplugged.
4. It is strongly recommended to use an ESD strap or other antistatic devices.
3.3
Pre-installation Checklist
1. Verify that your system meets the hardware and software requirements stated above.
2. Shut down your system if active.
3. After shutting down the system, turn off power and unplug the cord.
4. Remove the card from its package. Please note that the card must be placed on an antistatic
surface.
5. Check the card for visible signs of damage. Do not attempt to install the card if damaged.
3.4
Card Installation Instructions
Read all installation instructions before connecting the equipment to the power source.
The cards require a PCI Express x4 or x8 Mezzanine connector. Please consult the host machine
documentation for instructions on how to install a PCI Express Mezzanine connector.
The card is being installed in a system that operates with voltages that can be lethal.
Before opening the case of the system, observe the following precautions to avoid
injury and prevent damage to system components.
This product is with no bracket which is usually a part of the connector cage protec-
tion. Please refrain from touching the cage directly during installation.