27
UK
• Connect to 230 V, 50 Hz only. The
warranty is not valid if the appliance is
connected to incorrect voltage.
• Never try to repair the appliance your-
self. Please contact the store where
you bought the appliance for repairs
under warranty.
• Unauthorised repairs or modifications
will invalidate the warranty.
SPECIAL SAFETY
INSTRUCTIONS
• Always place the appliance on a dry,
level and firm surface well away from
any edges.
• The appliance should only be
switched on when the blender jug
with lid has been attached and con-
tains liquid and/or food.
• Never pour boiling liquid or very hot
food into the blender jug. Make sure
that the food has a sufficiently low
temperature to avoid burning/scalding
in case of skin contact.
• Liquid ingredients must be no hotter
than 50 °C and the blender jug must
be no more than 700 ml full. The
speed when processing hot liquid
ingredients must be no higher than
2, and the appliance must not be al-
lowed to run for more than 4 minutes.
• Never add liquid or food above the
maximum mark on the blender jug.
• Do not use the appliance if the
blender jug is cracked or damaged in
any way.
• Never put utensils or your hands
into the blender jug while the appli-
ance is switched on. Never use metal
utensils. Only use wooden or plastic
utensils.
• Please note that the blade may still
rotate for a moment after you switch
off the appliance.
• Be careful not to touch the sharp
edges of the blades during use and
cleaning!
• Do not lift the blender jug off the mo-
tor unit until the blades have stopped
completely.
• NOTE! Do not try to remove the base
and the blade unit from the blender
jug! These parts must not be disman-
tled, as the blender jug will then not
be sealed.
• NOTE! The appliance is equipped
with a safety switch to avoid acciden-
tal starts. The safety switch is only
switched off if the appliance has been
assembled as described in the in-
structions. If otherwise, the appliance
will not operate! If the appliance does
not start, we recommend you check
the appliance assembly thoroughly.
• NOTE! This appliance is equipped
with a thermal switch which switches
the appliance off if the motor over-
heats. If this occurs, allow the appli-
ance to cool down for half an hour
so that the thermal switch can reset.
If the same thing happens again im-
mediately, this is probably because
the blender jug is too full or contains
ingredients that are too hard/tough.
Pour more liquid into the blender jug
or empty the jug and start again with
a smaller amount in smaller pieces.
• Before using for the first time, or after
prolonged storage without use, wash
any parts that will come into contact
with food.
