MELICONI HP EASY, Инструкция по эксплуатации

Страница: 13 / 18

13
Installation
BASE (FIG. 2) Details of elements:
G. Power input (USB-DC 5V)
H. ON-OFF/ CHANNEL CHANGE Switch (B/A/OFF)
I. Aux socket (3.5 mm jack analogue audio input)
L. LED light (RED/BLUE)
M. Toslink socket (optical digital audio input)
HEADPHONES (IMAGE 1) Details of elements:
A. Volume c
B. Volume control -
C. LED light (RED/GREEN/BLUE)
D. On/off button
E. Aux socket (3.5 mm jack analogue audio input)
F. Micro-USB socket for charging batteries
Charging the battery of the headset
• The battery must be charged before using the headset.
• To charge the battery, insert one end of the micro-USB cable into the “ F ” socket of the headset and the
other into any USB socket available (PC / SMARTPHONE charger, etc.).
• While the headphones are charging, the “ C ” led light is lit blue; the light will go out when they are fully
charged.
• Do not use or wear the headphones while the battery is charging.
Connecting the charging dock with the audio source
NB: Before making the connections, make sure the audio source (e.g. TV) and the base are switched off
(move the “ H ” switch to OFF).
• Using the dedicated cable (USB-DC 5V), supply power to socket “G” on the base, using any USB socket
available.
• Identify the optical digital audio output on the TV or device you wish to connect.
• Take the digital optical cable TOSLINK (6) from the pack and remove the silicone protections from
the ends.
• Using the optical digital cable Toslink, connect the optical audio output of the TV to input “M” (OPTICAL
IN) on the base.
• If the TV does not have an optical output, use the 3.5 mm stereo jack audio cable (4) and connect
the headset of the TV to input “I” (AUX) on the base.
• Switch on the base (move switch “H” to A or B), and check that the “L” LED light is lit red.
• Switch on the audio source (e.g. TV) and check that the “L” LED light on the base is lit blue.
NOTES:
- For connections to the TV using the digital optical cable Toslink, you may need to enter the menu of the
TV, activate the headphone output and select the audio format PCM .
- For analogue connections (3.5 mm jack cable), it is advisable to turn up the volume of the TV; if the audio
signal is too weak, the base will not transmit (refer to the user manual of the TV).
• Whilst remaining close to the charging dock, switch on the headphones by pressing down on button " D "
for a few seconds, until LED light “ C ” turns green. Then release.
• Put the headphones on and use the buttons " A " and “ B ” ONLY to adjust the volume and obtain proper
sound reproduction.
If the LED light “ C ” remains red, or if the headset does not reproduce the sounds, or there is interference
with the audio signal, press the “ D ” button briefly to pair the base to the headset.
If the problem persists, refer to the “TROUBLESHOOTING” chapter.