Additional check
Check that some of the other
functions used on your original remote
control are working correctly.
If the commands function incorrectly
or erratically, you have probably
entered a code for a similar but
different remote control.
In this case, repeat the search
procedure from
point 2
.
1
. Make sure that the TV is ON.
2
. Hold down the SHIFT
and ON/OFF buttons together
until the light indicator at the
top starts to flash indicating
that the remote control is
programming.
3
. Release the buttons.
Within 15 seconds,
enter the code 000.
The light indicator flashes more
quickly to indicate that the remote
control is ready for the search.
4
. Point the remote control at the TV.
Press and release one of the
most frequently used keys
several times
STOPPING
when
the appliance responds correctly
to the command.
5
. When the TV responds correctly,
press SHIFT to confirm.
Three flashes
indicate that
the operation has been
completed correctly.
Identify and make a note of the
code which you have searched
for following the code noting procedure
(see “NOTING THE PROGRAMMED
CODE” section).
NOTE : THE LIGHT INDICATOR
STOPS FLASHING
The remote control leaves the
programming mode and the light
indicator stops flashing:
• if no buttons are pressed
for 15 seconds
• if the code search list is completed.
1
. Make sure that the TV is ON.
2
. In the code book enclosed,
look for the make of your TV
and make a note of the first
code indicated
BENEATH
the make previously identified
(e.g. Philips 103).
3
. Hold down the SHIFT
and ON/OFF buttons together
until the light indicator at the top
starts to flash indicating that the
remote control is programming.
4
. Release the buttons.
Within 15 seconds, enter the
code previously identified
(e.g. 103).
Three flashes
indicate
that the code has been saved
correctly. If not, try the code entry
procedure again from
point 3
.
Additional check
Point the remote control at the TV.
Check that the appliance responds
correctly to the commands sent.
If there is no response or the appliance
only responds partially or incorrectly,
it is probable that you have used
the wrong code. In this case, try the
procedure again from point 3.
This time, however, use the
NEXT CODE
in the list (e.g. 111).
Make a note of the TV code
used to program the remote control
on the adhesive label supplied;
stick the label inside the battery cover,
for rapid consultation.
NOTE : THE LIGHT INDICATOR
STOPS FLASHING
The remote control leaves the
programming mode and the light indicator
stops flashing:
• if no buttons are pressed
for 15 seconds.
• if an invalid make code is entered.
DIRECT CODE ENTRY
B
1
0
3
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
C
This operation may take up to 30 minutes.
SHIFT
0
0
0
SHIFT
SHIFT