SHIFT
SET-UP
Read these instructions
carefully before programming
your remote control!
MAKE SEARCH PROGRAMMING MODE
A
1
. Make sure that the TV is ON.
2
. In the code book enclosed, look for
the make of your TV and make a note
of the code indicated at the side
(e.g. Philips 001) or the code for the
make indicated by the arrow.
3
. Hold down the SHIFT and ON/OFF
buttons together until the light
indicator at the top starts to flash
indicating that the remote control is
programming.
4
. Release the buttons,
within 15 seconds, enter the make
code previously identified (e.g. 001).
The light indicator flashes
more quickly to indicate
that the remote control
is ready for the search.
5
. Point the remote control at the TV.
Press and release one of
the most frequently-used
keys several times
STOPPING
when the appliance responds
correctly to the command.
6
. When the TV responds correctly,
press SHIFT to confirm.
Three flashes
indicate that the
operation has been completed
correctly.
Additional check
Check that some of the other functions
used on your original remote control are
working correctly. If the commands
function incorrectly or erratically, you
have probably entered a code for a
similar but different remote control.
In this case, repeat the search
procedure from
point 3
.
Identify and take note of the TV
code which you have searched for
following the code noting procedure
(see “NOTING THE PROGRAMMED
CODE” section).
0
0
1
SHIFT
NOTE : THE LIGHT INDICATOR
STOPS FLASHING
The remote control leaves the
programming mode and the light
indicator stops flashing:
• if no buttons are pressed for 15
seconds
• if an invalid make code is entered
• if the code search list is completed.
In this case, go back to
point 3
or
switch to programming mode
C
.
FITTING THE BATTERIES
Before programming and using the remote control, fit the batteries.
The remote control requires 2 new AAA/LR03 alkaline batteries.
Insert the batteries as shown.
• The batteries must be changed once a year.
• Change the batteries if the light indicator starts to
flash during use, this indicates that the batteries are
low and should be changed.
• When you remove the batteries, fit the new ones
within 5 minutes or you may have to reprogram your
remote control.
• Make a note of the codes for your TV on the
adhesive label inside the battery cover. This note will
be handy if you have to reprogram your control.
To program the
Facile
remote
control, follow the indications
in section
A
,
B
or
C
.