The MEMO function allows you to record a sequence of functions (button) and combine it with a single call button.
Sometimes it is necessary to perform different operations in succession in order to obtain a certain result.
With MEMO function will be possible to automate a number of functions (also on different devices) without having to
remember and repeat every time you need
The MEMO function records the pressure of a maximum of
31
buttons, (including possibile changes of operating mode)
also
memorizing the pressure time and issue of the buttons.
Any button, except the
button, can be used to record a MEMO function; obviously the preset function on the button will
be lost, but it can be restored by setting again the activation code.
To recall a MEMO function, press the button to which was matched, the remote control will play the entire sequence
memorized ignoring any other command until its end.
You can not create recursive or nested MEMO (MEMO functions that call other MEMO)
More MEMO functions can be recorded in the various remote control operation modes, up to maximum total of
63
.
The recording of MEMO function can be repeated many times until the desired result is obtained, moreover the sequences
captured are kept in memory even with dead batteries or removed.
●
MEMO RECORDING
• On the MELICONI remote control
button until the LED lights
up; release.
• Press the
button again briefly and immediately press for a moment the button to which to combine the MEMO function.
• At this point the remote control is ready to record the desired button sequence; press in order the buttons to memorize with
the normal rhythm used to command the relative devices.
• To terminate the record procedure, press and hold
button, wait three flashes indicate that storage; release.
From now when the designated button is pressed, the MELICONI remote control will automatically reproduce the sequence
of buttons memorised.
Each MEMO function used reduces the number of available LEARN functions.
Reached the number of records available, the dedicated memory becomes full, preventing further use.
To free memory use one of the following procedures in relation to the data that you want to delete:
• DELETE FUNCTION BY SINGLE BUTTON
• ENTERING THE CODE DIRECTLY
• RESET THE REMOTE CONTROL
Connect the MELICONI remote control to a Personal Computer (Tablet / Smartphone) with Internet access through the
appropriate audio cable (included in the package) as shown in figure.
Operate as follows:
• Make sure the remote control is equipped with charged batteries.
• Connect the flat end of the cable to the three-pin connector in the battery compartment.
• Connect the jack of the cable to the audio / headphone output PC (green jack socket).
• On the
website, use the ACTIVATION OF REMOTE CONTROL tool and follow
the instructions.
SETTING VIA AUDIOCABLE
MEMO FUNCTION
