The Facile 5.1 LED remote control is equipped with Learn technology that can acquire and memorise signals from other
infrared remote controls. This feature is particularly useful in several cases.
To add or change a function connected to a button on the MELICONI remote control.
Having activated the remote control and checked it is working correctly, you may need to add or replace a function on one
of the MELICONI remote control buttons with another function you consider to be handier or more frequently used.
Assign some functions to some buttons to control other devices (example: /- SOUNDBAR).
To acquire the keypad of an original remote control when a suitable activation code cannot be found.
If no code on the MELICONI remote control is able to command the required appliance properly, you can capture and
assign to the various buttons the desired functions of the original remote control.
The Facile 5.1 LED remote control can learn up to a maximum of
63
signals coming from various original remote controls and
connect at will to the desired buttons (even if they have a different use to the one selected).
Signals can also be learnt and set on all the buttons on the MELICONI remote control, except the
button. Obviously the
preset functions are lost, but they can be restored by setting again the activation code.
The Learn operation can be repeated numerous times, and the signals captured are kept in the memory even if the batteries
are removed or go flat.
●
POSITIONING THE REMOTE CONTROLS CORRECTLY.
• Check that the batteries in both remote controls (the original and the MELICONI remote) are fully
charged; if semi-charged batteries are used the signal acquisition procedure may prove difficult
or fail completely.
• Position the original remote control in front of the MELICONI remote control so the areas which
emit the infrared signals are opposite each other at a distance of approximately 2 cm.
• On the MELICONI remote control
, wait a few seconds and then press
for a moment the
button.
• Within 30 seconds, press and hold down one of the buttons on the original remote control; the
LED on the MELICONI remote control should start flashing; if it doesn't, move the remote
controls closer together.
• Gradually move the original remote control away, making sure the two remotes stay aligned,
until the point at which the LED stops flashing; then move the remote control to half the previous
distance and keep both remotes in this position until the process has terminated.
●
CAPTURING SIGNALS.
• On the MELICONI remote control press and hold the
button until the LED lights up; release.
• Press the
button again briefly and immediately press for a moment the button to which to combine the capture signal.
• Press the button on the original remote to be captured, hold it down until the LED goes out and then release it.
IMPORTANT: If after releasing the button the LED comes back on, press the same button again until the LED goes out
once more.
• When the signal has been captured correctly the LED will produce three final flashes.
To capture other signals to connect to other buttons, repeat the procedure described above.
Each LEARN function used reduces the number of available MEMO functions.
Reached the number of records available, the dedicated memory becomes full, preventing further use.
To free memory use one of the following procedures in relation to the data that you want to delete:
• DELETE FUNCTION BY SINGLE BUTTON
• ENTERING THE CODE DIRECTLY
• RESET THE REMOTE CONTROL
LEARN FUNCTION
