Meler Cantho, Инструкция по эксплуатации

Страница: 26 / 66

FOCKE MELER GLUING SOLUTIONS
4-2
MELTER OPERATION
Warning: Before refilling the cylinder, ensure that the adhesive is the same
type as the existing one. Mixing different types of adhesive may damage the
melters. If you are going to change the adhesive, the unit must be cleaned
thoroughly.
Starting up the melter/applicator equipment
Before starting up the melter/applicator equipment, it is necessary to check
to see if the unit has been correctly installed and all its input/output and
accessory connections are correctly established.
It is also necessary to make sure that the equipment has been filled with
adhesive and that the operational parameters have been programmed.
To start:
1. Connect the melter/applicator’s power switch.
If the control card was turned off the last time the machine was disconnected,
it will remain tuned off when the machine is started up again (time display).
If the control card was on the last time that the machine was disconnected, it
will turn on when the machine is started up again.
2. Press the ON/OFF button on the control card to turn it on, if it not
already activated.
By default, the set point and real temperature values shown are those
corresponding to the tank.
The tank heating control LED (green) will light up and the tank will begin to
heat.
One it has reached 3° below the programmed temperature of the grille -3°C,
programmable delay timer starts until, guaranteeing fusion, the melter
receives permission to operate and the signal will be sent to the main
machine, indicated by the two corresponding (green) LEDs.
While the system is running the delay timer both LEDs remains blinking until
the programmed time value has been reached. If then, any other element has
not reached 3° below its temperature setting point, the LEDs turn off.
If the system is shut down, for any possible mode, when it is turning on the
delay timer only starts again if the tank temperature is 20° below setting
point .
Melter equipment displays
‘Cantho’ melters/applicators have two displays built into their control panel,
with three sets of 7 segments each for displaying the temperature values (set
point and real temperature), programmable parameters and alarms.
They are equipped with LED indicators to display the heating of each
component (1), as well as the temperature OK activations and the main
machine connection signal (2).
160 160 160 160
160 160 160 160
160 160 160 160
1
2