MELECTRONIC MTP 1406VS135, Руководство пользователя

Страница: 13 / 19

- 29 -
Before Switching on your TV
Power connection
IMPORTANT:
The TV set is designed to operate on
230V AC, 50 Hz.
Connections to the RF input socket
• Connect the aerial or cable TV plug to the RF input
socket located at the back of the TV and connect
the cable plug coming out from the TV out socket
located at the devices (VCR, DVB etc.) to this socket
as well.
Inserting batteries in the remote control handset
• Place the batteries in the right directions as seen
below.
• Remove the battery cover located on the back of the
handset by gently pulling upwards from the indicated
part.
• Insert two AAA (R03) or equivalent type batteries
inside.
• Replace the battery cover.
NOTE: Remove batteries from remote control hand-
set when it is not to be used for a long period. Other-
wise it can be damaged due to any leakage of batter-
ies.
Switching the TV ON/OFF
To switch the TV on
Your TV will switch on in two steps:
1- Press the power button located on the front of the
TV. Then the TV switches itself to standby mode
and the RED LED located below the TV turns on.
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a
programme number is selected,
or,
Press Programme Up or Down buttons on the front of
the TV or on the remote control, so that last switched
off programme is selected.
By either ways the TV will switch on and the RED
LED will turn GREEN.
To switch the TV off
• Press the stand-by button on the remote control, so
the TV will switch to stand-by mode and the GREEN
LED will become RED ,
or,
Press the power button located on the front of the
TV, so the TV will switch off and the GREEN LED will
turn off.
Operating the TV
You can operate your TV both using the remote
control handset and onset buttons.
Operating with the buttons on the TV set
Volume setting and programme selection can be made
using the buttons on the front panel.
Operating with Remote Control
The remote control handset of your TV is designed to
control all the functions of the model you selected.
The functions will be described in accordance with
the menu system of your TV.
Volume Setting
Press “ V+ ” button to increase volume. Press
“ V- ” button to decrease volume. A volume level scale
(slider) will be displayed at the middle of the bottom
on the screen.
Programme Selecting (Previous or next
programme)
• Press “ -P ” button to select the previous programme.
• Press “ P+ “ button to select the next programme.
Programme Selecting (direct access)
Press digit buttons on the remote control handset to se-
lect programmes between 0 and 9. TV will switch to the
selected programme. To select programmes between 10
- 99, you must use the double digit button "- -".
this OSD is displayed at the left hand upper
on the screen.
After then, press the digit buttons consecutively which
programme you want to select (eg. For programme
27, first press 2 and then 7). When it is late to press
any digit button this function will be ignored and the
display will be erased. In the same way it must not be
late to press any digit button after entering the first
digit. The limit of the delay time is 3 seconds.
Press directly the programme number to reselect
single digit programmes.
50083968-4-1428-FAV-ENG-1243 UK-AK36-PLL (FREKANS)-MN1P-T3X (COST).p65 31.08.2006, 14:05 29