MT-300 Pico Broadcaster
Operator Manual
__
10
setup in figure 1 or use the alternative setup below in figure 2 to change the MT300
network configuration.
If using the typical setup in figure 1, connect a PC and the MT300 to the router and set
the computers IP Address to a static IP address on the same subnet as the default settings
for the MT300 (e.g., 192.168.1.100). The LAN side of the router must be configured for
addresses within the 192.168.0.0 subnet.
Figure 2 – Alternative setup for device configuration
If using the alternative setup for device configuration, connect a PC to the MT300
Ethernet port and set the computers IP Address to a static IP address on the same subnet
as the default settings for the MT300 (e.g., 192.168.1.100).
Using your PC internet browser; type
http://192.168.1.194
in the browser URL field to
access the device webpage interface. The registration tab will be displayed.
Select the Advanced>Network tabs to display the Network Configuration default values
as shown below:
