Chapter 3 – Operation and care
8
Chapter 3 – Operation and care
Producing distilled water
DANGER!
The water is very hot. Steam can be emitted from the upper section.
Danger of burns.
Never remove the upper section if the ventilator motor is running.
Allow the water distiller to cool for 30 minutes before removing the upper section.
Proceed as follows to produce distilled water:
1.
Remove the mains plug and disconnect the connecting cable from the bushing of the distilling
chamber.
2.
Remove the upper section of the water distiller.
3.
Fill the distilling chamber up to the upper marking with c. 4 L tap water.
PLEASE NOTE
The use of hot water reduces the length of the process.
4.
Replace the upper section on the distilling chamber and reconnect the connection cable to the
distilling chamber bushing.
PLEASE NOTE
Check the seal in the upper section of the distilling chamber before every use. See:
Chapter 2 –
Commissioning
, p. 7.
5.
Place the glass flask (laterally rotated) under the distilling chamber discharge opening.
6.
Plug the mains plug into the mains socket.
7.
Press the START/RESET button. The ventilator motor in the upper section of the distilling
chamber begins to run.
Once the cycle has finished, the water distiller will switch off automatically. The distilled water in
the glass flask is ready to use. Close the lateral opening with the adapter cover.
8.
Remove the mains plug from the socket after use.
Discharge opening
of the distilling
chamber