MEITRACK T399 Bluetooth Vehicle Tracker User Guide
Copyright © Meitrack Group 2021. All rights reserved. - 5 -
You can set the following parameters by Meitrack Manager:
GPS speed range
,
GPS positioning accuracy
, and
Number
of GPS satellites
. After the GPS data filtering function is enabled, if all conditions are met, GPS data will be updated.
Note: This function can be enabled by Meitrack Manager only.
2.1.3
Setting the Output Port Status Based on Events
Users can control the output port status based on events.
For example:
1. When the device detects speeding, the buzzer makes sounds.
2. When the device detects unauthorized ignition or GPS antenna cut-off, the engine fails to be started.
3. When the device detects that the iButton reader or RFID reader is triggered, the engine starts.
4. When the device detects that an input is activated or inactivated, the output port is active or inactive.
2.1.4
Idling Detection
This function is used to detect whether a vehicle's engine is switched off while parking. To enable the function, input 2
must be connected to the ACC detection cable.
When the device detects that the ACC is on and the driving speed is 0 for one consecutive minute (default time), an
idling alert will be sent.
For details, see the section 6.5.4 "Setting the Idling Alert – B14."
2.1.5
Changing the I/O Port Mode
This function is used to change the I/O port mode. For example, change the active negative input to the analog port or
positive input.
For details, see the section 6.5.8 "Setting I/O Port Status – C08."
2.1.6
Starting the Engine by RFID or iButton
After swiping the authorized RFID card or iButton key, the driver must start the engine within one minute. Otherwise,
the device's output 1 will be triggered (engine cut-off), and thus the driver cannot start the vehicle. If you want to start
the engine, you must swipe the iButton key or RFID card again.
Before starting the engine, ensure that:
1. The device's input 2 is connected to the engine detection cable.
2. An iButton key or a RFID card has been authorized.
3. The device's output 1 is connected to the engine control cable through a relay.
4. The RFID ignition function has been enabled by Meitrack Manager or MS03 tracking platform.
5. The RFID event has been enabled on Meitrack Manager. Otherwise, the function will be unavailable.
2.1.7
CAN Bus Interface(Optional)
The device can read CAN bus data of a vehicle that supports the FMS protocol.