MEITRACK MT90A User Guide
Copyright © 2014 Meitrack Group All rights reserved.
- 9 -
5.
Charge the battery.
The battery is partially charged before shipped. Before
using the device for the first time, you are advised to
turn off the device and then charge the battery for 8
hours. To charge the battery, you can connect the
device to the adapter or a computer through the USB
cable.
Note: Do not remove the battery unless necessary
during charging. While charging, the device may heat
up. This is normal and does not affect your device’s
lifespan or performance. If the battery is low, it may
affect positioning and data transmission. In this way,
charge the battery before using.
Charge with the travel adapter:
Open the cover of the multifunctional jack of the
device. Plug the small end of the adapter into the
multifunctional jack. Then plug the larger end of the
travel adapter into a power outlet.
Note: Incorrect connection may cause serious damages
to the device. Any damage caused by misuse is not
covered in the warranty.
Attach a lanyard:
Slide the lanyard through the slot and hook it over the
small projection.
Once you have installed the battery and SIM card, you can turn on your device and start using it.
When you turn on the device for the first time, you will be prompted to set your device. For more information about how to set
your device, please read the following instructions.
7
Quick Operation Command
Before normal usage, common parameters must be set either by SMS command or by software.
7.1
Real-time Location Tracking
This section describes how to query the current location of the portable MT90A, ensuring that the GPS is working normally.
Call the SIM card phone number embedded in the MT90A, and hang up after the dial sound 2–3 times.
Note: If an authorized phone number was set by SMS command A71, only this phone number can receive SMS reports.
An SMS with a map link is received. Click the link to query the location.
