Meister MAS18V-22, Перевод оригинальной инструкции

Страница: 46 / 86

an ordinary screwdriver. Always
practise first!
• Starting:
Press the ON/OFF switch (6): The
screwing process will start. Press and
keep the switch during the screwing
process.
• Stopping:
As soon as the screw has been screwed
in or removed fully, release the On/Off
switch.
Selection knob for screwdriver/drill
function (fig. 5)
Use the selection knob for screwdriver/
drill function (1) to select between two
different rotation ranges.
• Switch position : 0–350 rpm for
turning screws in and out
• Switch position : 0–1000 rpm for
screw-driving and drilling
The speed range to be selected is
determined by the respective material
and the planned activity, and is to be
determined through work on a
specimen.
CAUTION! Carry out changeover
with motor stopped only.
9 – Mode of operation
Electronic rotation speed regulation
Using the electronic rotation speed
regulation), you can adapt the rotation
speed continuously to the respective
job.
• A light pressure on the On/Off switch (6)
= low revolutions to undo stubborn
screws.
• Hold down the On/Off switch = highest
possible revolutions for drilling.
CAUTION! Avoid the motor coming
to a standstill under loading when
boring or screw-driving!
Clockwise/anti-clockwise run
You determine the rotation direction with
the aid of the slide switch (3) above the
On/Off switch.
PLEASE NOTE! Change rotation
direction only with motor
stopped!
• Screw-driving in bolts: Slide switch to
Position R.
• Turning off bolts: Slide switch to
Position L.
• Safety position: Switch middle
position; in this position of the slide
switch the device cannot be put into
operation, e.g. in case of work
breaks, bit or drill change.
Torque setting
The screwdriver/drill has a 23-level
torque setting (8) designed to prevent
46
5451420-Akkubohrsc_man 04.12.14 10:16 Seite 46