6 System Installation
Installing a Module
1.
If a module is to be replaced, remove the installed module in accordance with the guide "
Removing a
Module
" on the previous page. Otherwise, remove the two Torx screws from the cover plate of the
unused slot. We recommend keeping the cover plate in a safe place for later use.
2.
Insert the module correctly into the two guide rails of the system chassis. If the module cannot be
inserted with minimal force, it is possible that the module is not properly seated in the guide rails.
In this case, you should pull the module out and try again.
Do not use excessive force to try and push
the module in!
Failure to heed this instruction may result in damage to the module and/or chassis.
3.
Once the module has reached the connector block of the system backplane, a little more force will be
required to insert the module into the connector block. Ensure that the module is locked securely into
place and that the faceplate of the module is flush with that of the adjacent modules or cover plates.
4.
Insert and tighten the two Torx screws again.
The installed module is now ready to set up for use.
IMS-LNO
Date: October 24, 2022
13
