Meinberg DCF77 PC32, Руководство по эксплуатации

Страница: 12 / 22

12
If the utility diskette is inserted in drive A: use the following command to copy the
files and subdirectories from the diskette to the hard disk:
XCOPY A:*.* /S
Using PCPSINFO.EXE
After the board has been installed in the computer the program PCPSINFO.EXE
should be run in order to see if the board has been properly installed. This program can
display its messages in English or in German language and the date and time in
formats used in the USA, the UK, or Germany. The default language and formats used
are derived from the DOS country code at startup. If automatic language detection
does not yield the desired result, you can force a language and date/time format using
a command line parameter or by pressing a function key when the program is running.
The command syntax is shown below:
PCPSINFO [P:xxx] [C:xx] [MONO] [?]
Usage of the command line parameters is described below:
P:xxx The board is installed using addresss xxx (hex). This parameter can be omitted if the
address matches the default address (300 hex).
C:xx Country code override. The default country code to be used is derived from the COUN-
TRY=.... entry in the CONFIG.SYS file.
xx may be set to 49 (Germany, 24h clock, dd.mm.yy), 44 (U.K, 12h clock, dd/mm/yy)
or 1 (USA, 12h clock, mm-dd-yy).
MONO Force monochrome display even if color display installed. May increase the readability
on LC displays often used with laptops.
? Displays a message how to setup port address and how to use the program. Output can
be redirected to printer ( append ">LPT1" to the command line) or file (append ">file-
name").
All the command line parameters are optional. In most cases the program is started
simply by entering PCPSINFO or, if the port address has been changed, PCPSINFO
P:xxxx. If the board can be accessed via the selected port address the screen displays
information as shown below: