Meinberg BPE-2000, Руководство по установке

Страница: 11 / 12

4.1 Configuring an BPE expansion card via the Web Interface
A simple BPE expansion card usually gets its signals directly from the internal backplane of the system. The
output signals of the card are pre-configured according to customer requirements.
If an output signal has to be changed, this must be
done via the pre-connected receiver - in the menu
"Clock
→
Switch Card" if you have a redundant system
or in the menu "Clock
→
Receiver" in systems with
only a single receiver. The BPE modules have no
direct configuration options. This information is also
displayed in the "IO Config" menu.
Figure: menu "Clock → Switch Card → IRIG Settings"
8 Date: 19th November 2019 BPE-2000