Page 18
S
ECTION
5 - C
LEANING
5
C
LEANING
WARNING!
Before ANY cleaning, check that the
circuit breaker/fused disconnect is in
the OFF position and that the unit is
switched off.
IMPORTANT
The headings
Daily Cleaning
and
Weekly
Cleaning
in this section are general
recommendations based on typical soiling.
If soil beings to accumulate, the unit should
be cleaned more frequently. Extensive food
soil deposits inside the machine work against
optimal performance. Some items may not
be cleaned as effectively, resulting in the need
for either a longer cycle or repeat washing. In
addition, heavy soiling in the wash water
increases detergent consumption.
5.1 Daily Cleaning (or as required)
1. The dishwasher automatically enters a
self-cleaning cycle when it is turned off.
The interior will be sprayed with hot, fresh
water as the booster tank empties.
2. AFTER this cycle ends and the machine
shuts down, open the door. Remove any
food particles, scraps or bones from the
scrap screens.
3. Lift out the scrap screens and clean them
thoroughly using a brush and warm water.
4. Lift out the two Active Plus filters. Clean
them thoroughly using a brush and warm
water. Be sure to use care to avoid dam-
aging the screen on the Active Plus filters.
5. MEIKO recommends that the door of the
dishwasher be left open overnight to allow
it to air thoroughly.
6. Reassemble all components into the ma-
chine before operation. Note the following:
-
The Active Plus filters MUST be rein-
stalled with the slotted end facing
DOWN. See Figure 5-1.
-
The scrap screens are keyed to fit
against each other. They MUST be
reinstalled in the proper order, and with
the round grates lined up with the Ac-
tive Plus filters. See Figure 5-1.
5.2 Weekly Cleaning (or as required)
Once per week, or as required, perform the
following steps:
1. Open the door. Remove and clean the
scrap screens and Active Plus filters as
described in Section 5.1, “Daily Cleaning.”
2. Remove and disassemble the arms as
shown in Figures 5-2 and 5-3. Clean the
arms with a brush and warm running water.
3. Reassemble all components into the dish-
washer. Note the following:
-
The Active Plus filters MUST be rein-
stalled with the slotted end facing
DOWN. See Figure 5-1.
-
The scrap screens are keyed to fit
against each other. They MUST be
reinstalled in the proper order, and with
the round grates lined up with the Ac-
tive Plus filters. See Figure 5-1.
-
There are four wash arms and four rinse
arms in the machine. Top and bottom
arms are identical and interchangeable.
Figure 5-1: Screen and filter removal
Scrap
screens (4)
Active
Plus
filter
Round grates are
aligned with Active
Plus filters
Slotted
end faces
DOWN
Replace the scrap screens
in the following order:
1
2
3
4
