UNPACKING
All MEIJI TECHNO microscopes are usually supplied in an expanded polystyrene, 2-part case and this
should be used for storage, possible transport in the future, etc. If your order includes a wooden
storage cabinet, release the fixing screws holding the limb and base into the cabinet and withdraw.
Unpack the microscope and its parts carefully. Do not discard any boxes or packing materials until the
contents of the shipping container have been checked against the packing list sent and your order.
If an EMZ Zoom stereo microscope has been shipped, base, limb and zoom stereo body will be
shipped together as a unit. Remove from the styrofoam back, holding the base in one hand and
supporting the zoom stereo body with the other.
Place the microscope and parts on a sturdy table or desk which gives firm and stable support. This
should be located where the atmosphere is as clean as possible, avoiding places where there is
excessive dust, moisture, heat or fumes.
ASSEMBLY
When in place, insert eyepieces in the eyetubes of the binocular body. Zoom stereo body are already
in place on the limb, as shipped. Cover with the plastic dust cover supplied until ready for adjustment
and use.
If you ordered zoom stereo body and stand separately, loosen the set screw and insert the zoom body
into the holder then tighten the set screw after setting at the desired position.
IMPORTANT!
Before plugging the illuminator into any electric outlet, make sure that transfomers and illumination bases
supplied to you are suitable to the current available. (When shipped, these will be labelled as to mains
voltage and cycles specification.)
UNPACKING, ASSEMBLY, PREPARATION FOR USE
4
Insert the eyepieces
into eyetube
Zoom body can
rotate 360 degree
on the holder
Holder
Set screw
Main voltage label
MAINS AC100V-120V
