Technical Support 1-800-345-8172 CASHFLOW SC66 Page-19
www.meiglobal.com Part # 252055066 G1
Periodic maintenance can improve the performance and extend the working life of a bill accep-
tor. Additional attention may be required if the bill acceptor becomes inoperable due to a
jammed object or acceptance rates fall below normal.
Cleaning the Acceptor Module
Note: You must remove the Acceptor Module from the chassis to open the front sensor area. Forcing the bill path open
without removing the Acceptor Module from the chassis will damage the connector board located at the rear of the
Acceptor Module. Remember to turn off the machine (as per machine manufacturer) when performing any cleaning.
•
Release the Acceptor Module from its normal operating position.
•
Open the Acceptor Module unit by pulling up on the yellow cap.
•
Clear the bill path area of any foreign objects.
•
Clean bill path and sensor areas as needed.
For stubborn dirt, a small amount of mild non-abrasive soap may be applied to a damp cloth.
Make sure no streaks or residual from the cleaning product remain on the bill path.
Note: SC66 does not require the use of a cleaning card. Never use a petroleum-based product to clean this
device! Petroleum based products will damage the bill path. Mild non-abrasive soap is prefered over alcohol.
Calibration
The SC66 series bill acceptor was designed not to require calibration. Thus, the unit has no
switch settings or calibration mode that allows a user to perform a calibration. Calibration may
only be performed by one of our trained technicians.
MAINTENANCE
