91398 Rev A.1 01/16
Page 8 of 8
•
Load Reading
– loads a previous reading (for re-display)
•
Configuration - allows the run speed and alarm levels to be set independently for
each individual MP
Machines and their measurement points are downloaded from DataMate trending and
asset management software using the supplied USB docking cradle.
The exact list of machines to be downloaded is determined by the user in DataMate.
There will also always be a machine downloaded named ‘off route’ that contains 10 MPs. This is done to allow
users to save readings for upload to DataMate where they can then be saved to a new or existing machine.
4.0 DataMate trending software
DataMate is a PC based software that allows users to view trends of vibration readings taken with the
MachineryMate
™ 800, to enable comparisons about machine condition. DataMate is intuitive and very easy to
drive. Full functionality is described in more detail in its User Manual. The software allows display of vibration
data in a variety of ways including vibration frequency spectra, bearing noise and ISO trend plots, waterfall
diagrams and can generate reports either manually or automatically (by sending out email alerts).
A free version of DataMate accommodates a maximum of 10 machines, each with 10 measurement points.
The full version for the software allows a maximum of 1,000 machines, each with 10 measurement points.
Contact Meggitt Sensing Systems at
for more information.
5.0 Accessories and options
Strobe and flashlight attachment
Press the Strobe button to display run speed and causes the strobe to flash at the displayed rate. Flash rate
can be changed using the arrow buttons. Run speed will automatically update.
Hold the Strobe button for 2 seconds to put the strobe attachment into flashlight mode for a continuous bright
light.
WARNING
: With strobe lighting moving parts can appear stationary and care should be taken not to touch
moving parts when using the strobe attachment.
Bluetooth connected headphone
Press the Headphones button to wirelessly connect to the optional set of Bluetooth earphones. This enables
the user to listen to an audio output of the accelerometer signals so any bearing noise can be heard.
6.0 Technical assistance
6.1 Technical assistance
For technical assistance, please contact Meggitt Sensing Systesms at 301-330-8811or email
[email protected].
6.2 Customer service
For customer service, please call 301-330-8811, or email [email protected].