Megger Digiflex Com, Инструкция по эксплуатации

Страница: 11 / 56

man_digiflex_com_en_02_5.doc 11
1.3 Safety Instructions
All persons involved in the installation, operation, maintenance and repair
of the
Digiflex Com must have read this manual carefully.
The Digiflex Com and its supplementary equipment are in accordance
with the current state of safety technology at the time of delivery. Owing to
the work processes involved, however, there may be parts of the unit and
its peripherals which cannot be given optimum protection without an
unreasonable reduction in function and usability. Good personal safety
practice is therefore indispensable in terms of the protection of staff and the
unit.
Therefore, please comply with the following safety instructions!
GENERAL INSTRUCTIONS
Work on the Digiflex Com and its peripherals must only be carried out by
trained and/or instructed staff. Other persons must be kept away.
This manual must be available for the supervisory, operating and
maintenance staff to refer to.
Improper use may endanger life and limb, the Digiflex Com and connected
equipment, as well as the efficient functioning of the unit (accident
prevention regulations). The
Digiflex Com may only be used for the
purpose for which it is intended by the manufacturer.
Always use the correct tools in perfect condition for all work.
Regular checks must be made to ensure that the relevant safety
regulations are being complied with during operation and maintenance.
Never operate the Digiflex Com and its peripherals if they are not in a
technically perfect condition.
Only parts specified by Megger as accessories must be used for the
Digiflex Com and its peripherals, as the necessary safety will not
otherwise be guaranteed. No mode of working which detracts from the
safety of the
Digiflex Com must be used.
Replace a accumulator only when the device is switched off and
disconnected.