Megavoice Envoy 2 E Series Скачать руководство пользователя страница 3

16

Plug player into any standard 

computer USB port using a “USB to 
micro-USB” cable for about 3 hours or 
until the LED stops blinking.

For solar charging, place the player 

with the solar panel facing bright 
sunlight for at least 8 hours.

Before storing the player for prolonged 
periods, make sure the battery is at least 
partially charged. If stored for extended 
periods, it is recommended to recharge 
the player at least every 6 months, in 
order to prevent the battery from losing 
its ability to recharge.

Should the battery become damaged 
and unable to accept a charge, you can 
still operate the player using the power 
cord (charger).

17

CHARGING/

COMMUNICATION

MODES

1. Player is on and in Playback mode (or 
Radio/Recording modes if so equipped).

2. Connect to computer: the player will 
enter Computer Communication mode 
and turn the unit off.

3. The player will connect with the 
computer.

4. Depending on the computer and the 
battery level, the LED will blink (Charging 
/communication indication).

5. After a few seconds, pressing on the 
Power Button will disconnect the player 
from Computer Communication mode, 
and return to the player’s prior mode.

18

6. At this point, physically disconnecting 
the player from the computer will stop 
the battery charging.

7. To connect to the computer again, the 
player will need to be disconnected, and 
reconnected.

8. While connected to the computer, the 
player’s battery will be charging, 
regardless of the mode it is in.

*Changing to Computer Communication 
mode is essential to allow programming 
of the unit/Firmware.

RESETTING PLAYER

DEFAULTS

Resetting player defaults (listed below) is 
done by pausing the player and pressing 

19

for 2 seconds (player will beep 3 

times and turn off).

• Last used mode
• Playback bookmark
• Playback speed
• Volume level
• Radio bookmark (Elite/Z, Equip/Z only)
• Preset frequencies (Elite/Z, Equip/Z only)
• Recording counter (Elite/Z, Echo/Z only)

PROBLEMS WITH

THE PLAYER?

If the unit will not turn on, please try the 
following:

1. Make sure the battery is charged 
according to the “Charging Instructions”.

2. If the battery is OK, force a reboot of 

20

the player by holding 

for about 10 

seconds. The player should restart 
automatically.

3. If #2 fails, reset the player by gently 
inserting the end of a paper clip for a 
few seconds into the reset hole on the 
back of the player, just above the 
left-most screw holding the back panel. 
This is the same as disconnecting/ 
reconnecting the battery. Then try to 
turn the player on.

4. If none of the above succeeded, 
please contact your sales representative 
for support.

21

• Care must be taken to set the volume 
at the lowest level that can be heard 
comfortably. Prolonged exposure to 
loud sound can cause gradual hearing 
loss.

• DO NOT expose player or battery to 
fire or extreme heat.

• Stop using player if you observe 
abnormal heat, odor, discoloration, 
leakage or deformation, especially near 
battery. Refer to a qualified technician 
for service.

• If the battery is removed from the 
player, handle it with care. Keep the 
exposed battery out of reach of children. 

WARNINGS

22

Envoy 2 E/EZ Series User Manual - US Letter - English - 2018.02.22-1.0.1

DO NOT burn, puncture, disassemble, or 
modify battery.

• If battery leaks, dispose of it carefully in 
accordance with all local laws. Wash any 
skin or clothing exposed to battery liquid 
and avoid swallowing or contact with 
eyes. In the case of swallowing or 
contact with eyes, seek medical care 
immediately.

Made in China

3/4

Отзывы: