MegaTech R/C HELICOPTER, Руководство по эксплуатации самолета

Страница: 11 / 16

11
TROUBLESHOOTINg gUIDE
If you are experiencing trouble, please follow these guidelines or call one of our
technicians at (201)662-8500. We will have your helicopter up and running in no time!
Always make sure your transmitter batteries are fresh and your
helicopter is fully charged, as this can be the cause of many
operational issues.
PROBLEM CAUSE SOLUTION
Rotors do not spin Rotors may be binding Check to make sure both rotor
assembly’s spin freely
Rotor blades only run for
short time before turning
off OR
Throttle/Tail rotor pulse OR
Control signal is lost
Transmitter is not pointed
directly at helicopter Make sure you always point the
transmitter at the helicopter at
all times.
Signal path from Transmitter to
helicopter is blocked Make sure there are no
obstructions
Transmitter is too far or too close
to the helicopter Move the transmitter closer or
further from the helicopter until
you regain signal.
You may have radio interference Try a different location
Helicopter does not hover,
fly straight, or starts to spin Improper take off Review take off procedure on
page 8
Helicopter is not trimmed
correctly Make sure the tail rotor is
trimmed to neutral or for stable
flight
Too much tail rotor control input
is being used Use smaller gentle inputs
Tail is not securely mounted on
the fuselage Double check to make sure tail
is secure and if needed use foam
safe glue to make repairs
Helicopter loses altitude
rapidly during turns Too much or too little control
input is given Reduce or increase the amount
of control input given to the
helicopter until it stabilizes
No power to radio control
transmitter and charger or
the transmitter RED LED is
flashing
Batteries in the transmitter are
incorrectly installed Make sure batteries are installed
correctly.
Batteries in the transmitter are
exhausted Replace the batteries with new
“AA” 1.5V alkaline batteries
Power switch is in the “OFF ”
position
Move power switch to the “ON”
position