7
trim-knob to the lower left of the right-hand turning button. Turn this knob until the
Micro-Fly does not move left or right during hands-off hovering.
8) Landing is accomplished by reducing rotor speed to the 1st rotor speed setting
where upon the Micro-Fly should gently land on the ground.
9) Practice your fi rst landings by only raising your Micro-Fly 12 to 24-inches off the
ground so as not to damage the model on rough landings from higher altitudes.
Once you feel confi dent, you may then take the Micro-Fly to greater altitude.
10) The Micro-Fly is designed for indoor use. However, if you wish to fl y it outdoors, it
must be fl own in no wind conditions. If the Micro-Fly happens to get caught in an
unexpected gust of wind, land it before it gets carried too far away in the breeze.
FLIGHT SELECTOR FEATURE
Your Micro-Fly is equipped with a fl ight selctor switch located on the bottom of
the model. The back switch position is for the “hovering-mode”, the center switch
position is for the “medium forward-fl ight-mode”, and the front switch position is for
the “fast forward-fl ight-mode”. We suggest that until you are familiar with the fl ight
characteristics of your Micro-Fly that you initially fl y in “hovering-mode” while you are
learning. Once you feel a bit confi dent, go ahead and give the other two modes a try.
We think you’ll fi nd “fast forward-fl ight-mode” a lot of fun, after you practice.
Forward
Forward
(Fast)
(Fast)
Hover
Hover
Forward
Forward
(Medium)
(Medium)
