5
INSTALLING THE TRANSMITTER BATTERIES
• Using your fi ngers, rotate the two
battery compartment cover retaining
tabs 90-degrees until they are in the
horizontal position. You’ll have to lift the
tabs slightly to move them off of their
retaining posts.
• Remove the battery compartment cover
• Paying close attention to each battery’s
polarity (+ and -) use the diagrams cast
onto the battery compartment back wall
to install them correctly. Install 8 “AA”-
size alkaline batteries.
NOTE: If your batteries are not installed properly the transmitter will not function,
and could become damaged.
• Use 8 NEW alkaline batteries. We recommend Megatech’s Super Plus brand.
• Replace the battery compartment cover and rotate the retaining tabs 90-degrees or
until the tabs are in the vertical position. Again, you’ll hear a “snap” indicating the tabs
are in the most secure position.
CHARGING YOUR MICRO-FLY
Your Micro-Fly features built-in Megatech extended run time high-performance
rechargeable NiMH (Nickel-Metal Hydride) battery that must be charged before each
fl ight (approximately 4-6 minutes charging time). NiMH technology indicates that
battery performance improves as you cycle them (charging them up, and running
them down). Optimum performance will be realized after the fourth or fi fth cycle. Your
transmitter also features a built-in charger that is equipped with an automatic timer. It
will automatically shut off when the Micro-Fly’s batteries are charged. The approximate
charge time is 4-6 minutes. NOTE: Never charge for more than 10 minutes or leave
unattended while charging. If you notice reduced run time, you may need to change
the transmitter batteries.
+
+
+
+
+
+
+
+
-
-
-
-
-
-
-
-
