MegaTech Air Strike, Руководство по эксплуатации самолета

Страница: 6 / 28

6
Assemble the Landing Gear
Next, fi nd the strip of white PVC reinforcing tape included with
your kit. This will be applied to the bottom of the wing. Remove
the backing from the PVC tape and stick the tape to the center
section of the wing as shown in
Figure 3
. Do not conform the tape
to the shape of the ridge in the center of the wing. Leave an air gap
between the tape and the ridge. Make sure that there is an equal
length of tape on each wing panel. Press the tape down fi rmly to
the wing surface. The tape will help to reinforce the wing against
excessive fl ight loads, which will naturally occur during steep
climbs or descents.
Figure 3 - Place PVC tape along bottom of wing as shown.
Step 2: Assemble the Landing Gear
Grasp the legs of the main landing gear. Gently squeeze the legs together,
and then push the gear into the slot on the bottom of the fuselage behind
the battery door. See
Figure 4
. Press fi rmly,
but gently until it is in all
the way. Then release the
pressure on the gear legs
and give them a gentle
tug to make sure they are
secure. To remove the
main gear, simply squeeze
the gear legs together to
release the gear from the
housing and pull it out of
the slot.
Figure 4 - Landing Gear Placement