next to it on the component goes into the square pad on the board, this is also labelled with a ”+” on the board.
16) Now solder all the rest of the capacitors in.
16B) Solder in the two polyfuses F1 and F2. Solder in the two inductors L1 and L2, leave a little gap
underneath. Solder in MOV1 (looks like a big round capacitor.) (Not shown installed in this photo.)
17) Now find the bag with all the chips in it, U6, U3, U7 and U4. Solder these in place, be careful to get them
the correct way round!
Note, the notch in the component must line up with the notch shown on the board. All notches face the top of the
board, U6 notch to the left.
18) Find Q16, (Ignition Transistor), D14, D15 and D16 (LEDs) Q4 and Q20 (small transistors) and U1 (black
