MegaPoints Controllers AutoSignal User Guide
Revision 10
megapointscontrollers.co.uk
Page 13
Linking units
You have two options to connect units together. Either:
a)
Use the three pin servo type connectors to connect to adjacent signal controllers (lead
supplied). This connector will carry power to adjacent units. Servo extension cables may be
used to provide a plug and socket wiring solution. Only connect power to one AutoSignal
board. It will be automatically distributed to the other members of the chain. (
See next
picture.
) Suggested maximum length of chain is 10 AutoSignals in each direction.
b)
Connect each unit to a power supply using the screw terminals and use a wire from the next
and previous screw terminals (bottom of board next to feather terminals) to communicate
with adjacent signal controllers. (
See next picture.
)
