6
IMPORTANT
READ THESE INSTRUCTIONS CAREFULLY AND NOTE THE SAFETY INSTRUCTIONS AND WARNINGS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE TO PROPERTY AND/OR SERIOUS PERSONAL INJURY.
KEEP THIS INSTRUCTION MANUAL SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS AND WARNINGS
-
Read and understand all warnings and instructions before use.
-
Do not overload the jack stands.
-
Always use jack stands on level, solid ground. Never use on slope, inclined, angled or soft surfaces.
-
Always use jack stands in pairs, on the same axle and at the same height. Jack stands are not to be used
to simultaneously support both ends or one side of a vehicle.
-
Inspect jack stands before each use.
-
Support the vehicle only on areas specified by the vehicle manufacturer.
-
Make sure the load and jack stands are stable before getting under the vehicle.
-
Center the load on the saddle.
-
No alterations shall be made to the jack stands.
-
Failure to follow these warnings or instructions may result in personal injury and/or property damage.
WARNING:
The warnings, cautions and instructions discussed in this instruction manual cannot cover all pos-
sible conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into any product, but must be supplied by the operator.
2. SPECIFICATIONS
Max. capacity
12 tons
Min. height
465 mm
Max. height
715 mm
3. OPERATION
1.
Inspect the jack stands before each use. Do not use if bent, broken or cracked components are noted.
2.
Put the jack stands on hard level ground.
3.
Adjust the jack stand height by raising or lowering the adjustable part (the lever must be lifted up before
lowering the adjustable part). Always place the load on the center of the saddle.
4.
For safety reasons it is recommended that the jack is not removed while the jack stands are supporting the
vehicle. However, make sure that the vehicle rests on the jack stands, not on the jack.
5.
Prevent corrosion. Clean as needed and wipe with an oiled cloth. Keep in dry area when not in use.
GB
