Megamaster 3 B Plancha, Инструкции по сборке и эксплуатации

Страница: 5 / 16

5
SAFETY INFORMATION
The Fuel System
Gas grills are used safely by millions of people when following simple safety precautions.
The items in the fuel system are designed for operation with this grill. They must not be replaced with any other brand.
(See parts list for replacement items.)
GAS BURNER : The gas burner is constructed of stainless steel and should not require maintenance other than
inspection for insects/nests inside the air intake slots.
LP GAS REGULATOR CAUTION
The gas pressure regulator provided with this appliance must be used. This regulator is equipped with the required
orifice and is set for the required outlet pressure for this appliance. This combination of orifice size and pressure
regulation specifications provides the cooking performance intended by this Table Top 3B Plancha. Substitution of
regulator by any other device or any other manufacturer is dangerous and could result in serious injury. The correct
type of regulator to be used is 2,8kPA low pressure regulator.
FUEL SUPPLY HOSE
The hose connected regulator provided with this appliance is 3.7 feet (113.3cm) length. Keep the fuel hose away from
any heated surface(s).
LP GAS FUEL : Warning
– LP Gas is a flammable gas. Improper handling may result in an explosion and/or fire and
serious accident or injury. Your grill is designed to operate with LP Gas only and is equipped with the proper orifice for
LP Gas.
Caution : Do not connect this grill with any gas supply other than LP Gas. LP Gas is heavier than air and settles in
lower areas. Make certain adequate ventilation is available when using your grill. The gas cylinder may be stored
outside in a well-ventilated area out of the reach of children when the grill is not in use.
The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or any other
enclosed area. The Table Top 3B Plancha may be stored indoors if the LP gas cylinder is removed and stored
outdoors. The LP gas cylinder (not included) is threaded for connection directly to the gas regulator supplied with this
appliance. Care should be taken when threading the cylinder to the regulator to engage threads correctly to achieve
the proper and intended connection. When disconnecting or connecting the gas cylinder, be careful that the regulator
does not strike the grill, the ground, or any other surfaces. Replace the protective cap over the threaded cylinder
connection when removed from grill. If any difficulty occurs when connecting or disconnecting the cylinder to the
regulator assembly, contact your local gas supplier for assistance.
When reconnecting the LP gas cylinder to the regulator, be sure to hand-tighten until snug. This connection should be
inspected for damage and leak tested after each reconnection.
To Do a Leak Test , make a soap solution of one part liquid detergent and one part water. You will need a spray bottle,
brush, or rag to apply the solution to the fitting. Bubbles indicate leaks
Check all gas supply fittings for leaks before each use.
Do not use the grill until all connections have been checked and do not leak.