AUGUST/30/2004
STOP THE MELODY SOUND ONLY:
While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transceiver to stop melody
sound only
CLEAR THE FLASH ICON AND MELODY SOUND:
While triggering the alarm the LCD screen will alert
user through melody sound and flashing trigger icon, press the
button 3 times within 3 seconds will clear
the flash icon and stop melody sound on the LCD screen transceiver.
NOISE ABATEMENT CIRCUIT:
You system has “Noise Abatement Circuit”. It prevents annoying repetitive
trigger sequences due to faulty door pin switches or environmental condition such as thunder, jackhammers
airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each time, the same sensor or
switch is triggering the alarm. “Noise Abatement Circuit” will interpret this pattern of triggers as false alarm.
After the fifth trigger, “Noise Abatement Circuit” ignores, or bypasses, that sensor or switch until the other
sensor or switch is trigger.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door for
six full cycles, the doors will be bypassed until the trigger ceases.
L. SYSTEM’S TRIGGER CHECK
(For two-way transceiver operation only)
Press the transceiver
button first, within 3 seconds press
button. It responds
with one melody sound and all trigger’s records will immediately displayed on the LCD
screen.
Note:
If it has no responds then you are out of range.
M. SYSTEM’S STATUS CHECK
(For two-way transceiver operation only)
When you want to check the system’s present status through the LCD screen, Press the
transceiver
button first, within 3 seconds press
button. It responds with one
melody sound, the LCD screen should be illuminated.
Note:
If it has no responds then you are out of range.
N. DRIVER PAGING / LOSE & FOUND
(For two-way
transceiver
operation
only)
It is useful the event that someone wants to page the driver of the parked vehicle or
someone cannot find his LCD motorcycle remote transceiver.
Under the ignition switch “off” condition, press and hold the valet switch for 2 seconds to
page the driver, one chirp sound shall be emitted from the vehicle and the paging melody
sound continues sounding from you Remote LCD transceiver and “
” indication flashes
on the LCD screen.
O. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
P. IGNITION CONTROL DOOR LOCK/UNLOCK.
(See Alarm Feature
4
Programming).
If the vehicles door locks have been interfaced to the security system, the system will automatically lock
the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is
turned “OFF”.
MEGA3700OP
5
