29
Travel Pal www.mega-motion.com
V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device requires occasional troubleshooting. However, most problems that arise can
usually be solved with a bit of thought and common sense. Many of these problems occur because the
batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below
develops.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
BEEP CODE
POSSIBLE CONDITIONS
SOLUTION
1,1
1. Temperature >197.6° F (92
°
C) or
<-13° (-25°C).
2. Excessive load on vehicle.
3. Operation in extreme environ-
ments.
4. Electromagnetic brake not releas-
ing.
Let your Travel Scooter cool or move it to a
warmer place. If necessary, push the main circuit
breaker reset button.
1,2
1. Throttle input wire open or shorted.
2. Throttle pot defective.
3. Wrong throttle type selected.
Contact 1-800-MEGA-508.
1,4
1. Battery voltage <16volts.
2. Bad connection at battery or con-
troller.
Charge batteries and/or check connections.
1,5
1. Battery voltage >32 volts.
2. Vehicle operating with charger
attached.
3. Intermittent battery connection.
Disconect charger.
Check battery connections.
2,1
1. Main contactor driver failed open.
Contact 1-800-MEGA-508.
2,3
1. Main contactor welded or stuck
open.
2. Main contactor driver fault.
3. Brake coil resistance too high.
Contact 1-800-MEGA-508.
2,4
1. Main contactor driver failed/closed.
Contact 1-800-MEGA-508.
3,1
1. Misadjusted throttle.
2. Broken throttle pot or throttle
mechanism.
Contact 1-800-MEGA-508.
3,2
1. Electromagnetic brake driver
shorted.
2. Electromagnetic brake coil open.
Turn key to off position, then push freewheel lever
to drive mode and restart Travel Scooter.
3,3
1. Low battery voltage.
2. KSI and throttle turned on at same
time.
Charge batteries.
Restart the Travel Scooter without touching the
throttle control lever.
