Cleaning and Maintenance
Installation Maintenance. The operator has to make sure that the unit is operating safely and has the installations and electronics
checked by an expert every 2 years.
The following points must be considered during the inspection:
1)All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
2) There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).
3) The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments. Further
instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems have to be
removed.
4) Fixture must only be cleaned from the outside using only dry towel.
5) If fixtures fan is not functioning please have service technician replace it.
Note:
There are no serviceable parts inside the device. Maintenance and service operations are to be carried out by authorized
dealers.
Replacing the fuse:
When possible, only replace the fuse with the same type and rating.
Replacing the power cable:
If the power cable of this device becomes damaged, it has to be replaced by authorized dealers or
trained professionals only.
Should you have further questions, please contact your dealer.
Installation
Caution!
1. The Installation must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures, if you have doubts concerning the safety do not install.
3 Unit is to be 24 inches away from flammable materials.
4. Space between the base and surface should be properly sealed to avoid liquids entering the base unit.
When installing the fixture it is very important that you follow common safety procedures. Instillation requires extensive
Experience including but not limited to calculating working loads and periodic safety inspections. If you lack these
Qualifications, do not attempt the installation yourself, instead use a professional.
The installation location of the fixture has got to be built in a way that it can hold 10 times the weight. Installation should
Be checked at least one time every 2 years by a skilled technician.
10
