MEFE—Mitchell Engineering Food Equipment Pty Ltd
23 Storie Street Clontarf QLD 4019 Australia
www.mefe.com.au | [email protected]
Page 3
+617 3283 4536
Free AU 1800 669 006
Operation Instructions
1.
Temperature measurement: Approach the front of the thermometer within sensing range (5—10cm) (F).
2.
Mode switching: Gently insert a 3mm diameter screwdriver into the hole on the back of the device and press down on
the button (G).
3.
Temperature selection: Single press and cycle between “C” and “F” for Celsius or Fahrenheit.
4.
Work mode selection: Long press the mode switch button for 3 seconds to switch the measurement work mode be-
tween Body, Surface, and Counting Mode.
Battery Install, Replacement, and Recharging
1.
Remove the four screws on the back cover and open the base. This device uses a rechargeable 18650 Li-ion battery.
2.
To charge the battery, connect the device via the USB cable to any USB interface. You should see a light through the
bottom hook hole indicating the device is charging. Red requires charge, green indicates fully charged.
Installation Methods
F
Nail hook
Tripod mounted (tripod not supplied)
Double-sided adhesive tape
G
